Application range These vacuum pumps with vanes are mainly used in agriculture for filling and emptying slurry tanks, Properties These pumps can generate both positive pressure and vacuum, Benefits As B.P. pumps are tested, inspected and packaged with the utmost care, trouble-free start-up is 100% guaranteed, Nominal volume flow rate 2750 l/min, Drive type Hydraulic, Direction of rotation Clockwise (CW), Ballast air injection system No, Lubrication system type Forced, Vane type Standard, Crash protection system No, Max vacuum 0.9 BAR, Max. relative pressure 1.5 BAR, Power requirement for max. pressure 7 kW, Power requirement for max. vacuum 4.9 kW, Hydraulic motor required capacity 38.5 l/min, Diameter of hose connection 45 mm, Safety valve connection diameter 1-1/4 Inch, Total length 456 mm, Total width 342 mm, Height 480 mm, HMounting holes diameter 15 mm, Mounting holes to shaft end distance 194 mm, Mounting holes to end distance 90 mm, KShaft centre to left side end distance 164 mm, XShaft centre to right side end distance 178 mm, LShaft centre to bottom distance 142 mm, Max. shaft rotation 1400 r/min, Weight 69 kg 28 1
Part numberMEC2000H EANUnitEach DetailsEach pump is subjected to a final check in the factory, in which the vacuum, compression and lubrication are tested, among other factors A test report relating to the serial number is drawn up for each pump Application rangeThese vacuum pumps with vanes are mainly used in agriculture for filling and emptying slurry tanks PropertiesThese pumps can generate both positive pressure and vacuum Technical infoComposition of the part numbers: MEC = series, 8000 = type, H = hydraulic drive On pumps without automatic lubrication (no "A" in the item number), the pump is equipped with a forced lubrication system that is adjusted using dripper nozzles Automatic lubrication available on request On pumps without automatic lubrication, the quantity of lubrication oil is set in the factory and cannot be changed without a tool In the case of forced lubrication, as with automatic lubrication, the function must be checked at all times during operation Hydraulically driven pumps rotate clockwise. Anti-clockwise rotation available on request The direction of rotation is determined when the axle to be driven is aligned with the observer Oil to be used for lubricating the vanes: genuine oil from B. P. (item number BP5070) BenefitsAs B.P. pumps are tested, inspected and packaged with the utmost care, trouble-free start-up is 100% guaranteed Nominal volume flow rate2750 l/minDrive typeHydraulic Direction of rotationClockwise (CW) Ballast air injection systemNo Consists ofThese pumps are supplied with standard vanes. Long-life vanes available on request Without pressure relief valve and vacuum valve The pumps are delivered without lubrication oil (item BP5070) Including hydraulic base for mounting the hydraulic motor Without hydraulic motor and key bush Lubrication system typeForced Vane typeStandard Crash protection systemNo Max vacuum0.9 BARMax. relative pressure1.5 BARPower requirement for max. pressure7 kWPower requirement for max. vacuum4.9 kWHydraulic motor required capacity38.5 l/minDDiameter of hose connection45 mmSafety valve connection diameter1-1/4 InchATotal length456 mmBTotal width342 mmCHeight480 mmHMounting holes diameter15 mmIMounting holes distance227 mm172 mmEMounting holes to shaft end distance194 mmGMounting holes to end distance90 mmKShaft centre to left side end distance164 mmXShaft centre to right side end distance178 mmLShaft centre to bottom distance142 mmMax. shaft rotation1400 r/minWeight69 kg
|
.png){kind=logo}
